Jump to content

T-800 Terminator Pack 4 - Stage 39


Recommended Posts

Stage 39, connecting the shoulders:

230115997_Picture1.thumb.png.cead165898b9f194d43b5b872834bea2.png

 

The two joint inserts fit into the shoulder connector. No glue:

574266973_Picture2.thumb.png.fa0d9745743dbe612b2aaf3b6ff8028d.png

 

Now I turn the shoulder connector over and put a sprung washer into each hole. Then a nut goes over each sprung washer. the nut should be orientated like the image on the right:

650914472_Picture3.thumb.png.a6fd133b4264165de901c9833d35b894.png

 

Next, I take two 16mm screws and fit a sprung washer over each. One of the screws goes into the right shoulder/arm assembly like so:

83119264_Picture4.thumb.png.77807a4c445e22c233506508e207951a.png

 

The shoulder connector attaches to the arm assembly. I hold the washers and sprungs with my finger until the screw holds everything together.

562337379_Picture5.thumb.png.9af6746820cc91c0da375b8dd4598228.png

 

Then I repeat and screw on the other shoulder. You will need to hold loose washers and sprung parts again until the screw joins to them:

1075885457_Picture6.thumb.png.42cb5e9b2a8d0357ee506464d81ded2b.png

 

Stage complete

27499678_Picture7.thumb.png.c1c33a34ac521bc25f5713c4de21be3b.png

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...