Pack 2- Stage 12. The fuel injection pump.

[Mark, The Master Modeller]

Stage 12 gives us the fuel injection pump.

There's quite a lot to do in this stage.  Start by screwing the toothed gear wheel to the fuel pump body.

Fit the connector bracket with a couple of screws.

Now turn the pump over and push one of the side covers in place.

Fit the out half pump body and then push the side cover in place.  I needed to scrape some excess paint to get a good fit.

Fit the pump base with another screw.

Fit the pump housing with 2 screws.

Push the housing cover and panel in place.

Fit the pump to the intake cam cover, along with the other toothed gear wheel.

The toothed belt can now be fitted.

The 12 fuel nozzles (unions might be a better word?) to the top of the pump.  These can be glued in if necessary.  Note that the rounded end points upwards.

That completes this stage, and this pack.