Administrator Mark, The Master Modeller Posted June 14, 2022 Administrator Share Posted June 14, 2022 Stage 34 gives us the landing gear motor. Put the landing gear assembly in place. You may need to adjust the position of the bearing fitted in stage 29, but this is easy to slide up or down the shaft until it fits into the recess. Secure the landing gear assembly with 2 screws. No need to fully tighten them as they will have to come out again a little later on. Push the gear wheel onto the motor shaft. It needs a firm push and must go all the way on. Push the motor into its slots. It doesn't matter which way up it goes. Run the wire out of the frame along side the other wires. Drop the gear into place. This was assembled in stage 32. Finally, fit the motor cover in place. This is secured with 4 screws, but again, it will need to come off again later. This completes the stage. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.