Jump to content

Pack 2 - stage 5. Continuing the engine.

Mark, The Master Modeller
 Share

Recommended Posts

  • Administrator
Mark, The Master Modeller Power Contributor

Mark, The Master Modeller

Posted
  • Administrator
Posted

Stage 5 gives us another hull section and some more engine parts.

P5260197.thumb.JPG.7353cd4c95bf28fc42d30324c2ff6f99.JPG

The first task is to take the small connecting rods and clip them to the connecting shaft.

Note that the shaft has a flat protrusions on one side and is smooth on the other.  The protrusions should be on the bottom and clip the connecting rods over the top.  

P5260198.thumb.JPG.dd5986e8bdcc14fe537da9fc1b7aad09.JPG

You can see the rectangular protrusions in this photo as the shaft has been turned over.  Clip two of the link sections to the connecting rods as shown.

P5260199.thumb.JPG.c7322ad9f7a48a3292c0071de731f0e5.JPG

Now clip the valve rods to the link sections.

P5260200.thumb.JPG.1a4ccf0cd17a57d305bdb4eecb225e9a.JPG

This completes this stage.  The hull section is kept until the next stage.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...