Super snake passenger seat

[Chooksclan]

Hi. Has anyone else had trouble with the rear upright of passenger seat? The front cushion of the rear section does not sit flush (at the bottom of the rear cushion) - there is a gap between the cushion and the seats plastic chrome frame. Annoying. Should I pull it apart to check all screws are home? I’m afraid I will tear the cushion in some way. 

[General Lou]

11 hours ago, Chooksclan said:

Hi. Has anyone else had trouble with the rear upright of passenger seat? The front cushion of the rear section does not sit flush (at the bottom of the rear cushion) - there is a gap between the cushion and the seats plastic chrome frame. Annoying. Should I pull it apart to check all screws are home? I’m afraid I will tear the cushion in some way. 

My seat in the car I am building looks fine. Could you send a photo?

This is mine:

 

[Chooksclan]

The drivers seat is fine. Don’t know why the passenger seat has the gap

[Mor Draka 09]

It looks like you may not have seated the back of seat correctly in stage ten, or there maybe some flashing on the back of the part stopping it from seating correctly

[General Lou]

On 7/6/2020 at 1:54 AM, Chooksclan said:

The drivers seat is fine. Don’t know why the passenger seat has the gap

 

I have had a look at my Super Snake. The passenger seat on mine is fine, like the drivers side. We will send you a new seat if it still isn't going in

 

[Chooksclan]

I’m not sure if I should pull the seat trim off? I’m afraid I’ll rip it?

[General Lou]

On 7/7/2020 at 12:38 PM, Chooksclan said:

I’m not sure if I should pull the seat trim off? I’m afraid I’ll rip it?

Can you private message me with your address and I will send a new seat out for you.