ILLOGI7ECH

Hi Sam. I contacted Agora Models via email and was told that they do not ship the Titanic to Australia, so the display case will not be available to me. Is this the case ? (pun intended) Will Australians be able to purchase these from Agora, or will I have to look elsewhere ? I noticed the Titanic isn't even on the main page for Agora Models anymore. Thanks.

I went to a museum once where they had the old school drag cars and I was able to sit in one. I don't know how they did it back in the day. If you have a closer look you can see that the driver sits literally directly on top of the differential. You were surely in for some hell if it ever exploded under power.........

Yeah I know it's around but if I am going to do a part works bike, it would have to be a classic. Not a modern Moto GP bike. Cheers.

I'm a bit longer in the tooth these days, but when I was younger I also had the RD350LC, and the air-cooled 400 ! The 400 handled like a brick and took a while to stop with the single piston solid disc front end, but it was fully ported with expansion chambers so the power delivery was pretty savage 😁

I'd be all over either one of these classics.......

I noticed when doing this stage yesterday that the LED board would not sit flat. The cause of mine not sitting flat were the locating pins on the ventilation hoods. These were too long and protrude too far through the superstructure. I just filed a small amount from the pins, so that when the hoods are fully seated, the pins sit flush with the underside of the superstructure and no longer touch the board. As always, do a test fit before glueing anything.I hope this helps someone that may run in to the same issue. Cheers.

Hehe. Just my poor attempt at humour. It was a quote from the movie "Lawless".

Now you all outta to know better than to come around here when Howard's been on the stump whiskey for a few days. You give my regards to Special Deputy Rakes.

I'm not there yet, but the 2 fairlead rollers and the 2 winches get replaced with a different colour. These and the replacement parts for the forecastle deck come in issue 21.

Hi Sam, I didn't subscribe through Hachette or Agora. I'm getting the Titanic through my local newsagent. (I didn't know Agora were distributing the Titanic when I started 😒)I noticed there are some Facebook people around my neck of the woods in Australia that are starting to receive the first binder. Are these binders available to Australians to purchase seperately through Agora ? If so, how to I get my hands on them ? Thanks.

Loved the start of that show with the howl and the rising chopper. Was based on a Bell 222 I think, but without the stealth mode and the supersoninc speed 😁

Hi All, I'm only very early on in the build. (Just completed stage 4).I didn't suscribe through Hachette or Agora. I know, shame on me. I went through a newsagent before I became a member or even knew about Agora ! I haven't seen the display cases advertised or shown anywhere apart from the subscription literature for the UK people. I know now it would have been cheaper to subscribe, but will a display case for the Titanic be available to us Australians further on down the track ? Cheers.

I was just asking as I have seen some "3rd party" hatches just stuck down with tape because they dont have the lugs. I would prefer the lugs to be there to fit into the original lug holes. Cheers.

Do these loading hatches screw to the deck or are they stuck down with double-sided tape ?