Rickash

In stage 86, why are the left and right front car mountings different? I've taken care to install them properly, but in stage 93 the left one interferes with installation of floor assembly. Has anyone experienced the same? Hope I don't have to take it all apart...

Thanks, this helped out to see where the spokes are better. I had to take 2 wheels apart as I made an error aligning the second set of outer spokes... had to cross them correctly. Slightly damaged the rim on one so it will go into the trunk also.

I'm not sure exactly what you mean with the black paint... can we see a pic detailing your tip? I also found blinding reflections that slowed me down during the assembly. Spare spokes would very much be appreciated as I too dropped one... was lucky to retrieve it! Phew! At pack-4, stages 27 and 28 have been mislabeled left and right... is it just my pack or are they all like this? Builder beware!

I also found the M2 nuts would not go in. What I tried was carefully use a pointy mini file to "scrape" the inside walls of the hexagon recesses, just enough to remove the chrome paint. I used your tip of pushing the nuts in with a screwdriver, and it worked great.

Hi... I have a few questions regarding my Terminator build. In Pack-2 Stage-14 Steps-1-9, there is the forearm assembly and I feel that the Lower Arm Tubes 14-1 and 14-2 remain very loose after tightening the 14-4 screws. I left it as is until Pack-3 Stage-24 had me join the arm and hand assemblies via the ball-joints. I noticed that the hand is very "flimsy" I am considering making a bushing that would slip onto parts 14-3 between 14-2 and 12-1. What are your thoughts on this? Has anyone had this problem? If so, what is your recommendation for fixing it? Thank you, Richard.