Robbert

When attaching the body to the chassis, the holes didn't align very well. It's very disappointing to see that small deviations from previous issues now cause the model not to fit together. Same with the wobbly doors.

The frame is too fragile. Even while pressing just on the frame, it didn't click into place. For both front windshield and back window one of the clips broke and now the frame is very loose.

I have the exact same problem. The hinge is tight to the body, but still the doors are wobbly. I'm going to try and remove the door panels to fix the hinge.

Is it correct that there's about 7 cm of hose sticking out at the wheel side? (poking through the hole) Is this still needed or can it be trimmed down?

Hi Lou, I just fitted your build replacement steering column. See the photo what happens. The steering column splits when it is fitted. The steering wheel doesn’t fit on. I will build the new unbuild replacement and see what happens. With kind regards, Robbert

Hi Lou, I received the replacements today. I will try them out once I get the next issue and let you know. Thanks again!

Here’s a video of the steering wheel coming off without effort. You also see mee clicking it back on and removing it again. FullSizeRender.mov

Hi Lou, The steering wheel does turn, but the silver/brown part is just not fixed, it's very loose. On the photo it's indeed the pin circled in blue, but it's for all 4 pins. I can't move the interior assemble more forward, because of the steering cog, which is allready where it's supposed to be. The wire is not in the way and is fitted properly. Could it be that the black ring on the steering axle is not far enough on the axle, so that the lower part is too long (causing the whole assembly to misalign) and the upper part is too short (causing the steering wheel to fall off constantly).

Yes, it's all the way in (I don't see any of the flat area). Every time I turn the steering wheel, it comes off, also the button only can be pressed when the steering wheel is slightly turned (I followed the instructions to the letter). In the photos you should be able to see that the interior pins don't align with the chassis slots, even though the steering axis is in the right place. IMG_4141.HEIC IMG_4140.HEIC IMG_4143.HEIC IMG_4142.HEIC

For me the steering wheel is very loose on the steering axis. Also the interiot pins do not align with the chassis holes after fitting them together. Can't see where I went wrong.