Karl

I’m not good with the plugs but I was able to push the pins in and solder them in + you can get the plugs off the board if you are gentle with a knife and rock them up a little at a time then you can slide them back into position. I would also suggest you check the little second board that all the lights go through just in case.

Ok good to see you have made some progress, l have found that the gun barrel needs more clearance in the turret to recoil and activate the led in the barrel good luck.

It was my new little board that was faulty

I’m in Adelaide my new circuit board was faulty l used the original, so the parts l used were the new main board and new ribbon cable because the plugs are opposite to my original then plug them in and that made my head lights and turret work correctly but please check that the new little board has the plastic connector plugs in the same way round as the original . You have to be very careful when you unplug the connectors because it pulls the pins out of the circuit board, try this and let me know how you get on good luck with it Karl

Hi palian looks like you are in Australia, l am as well. I may be able to help you get your tank working, I have had all of the same issues with my tank as you have with yours and I now have all functions working, although it is very underpowered kind regards Karl

Hi to all tank builders l have just finished fitting the pack 13 and the tank has all working functions however the tank is badly underpowered and struggles to turn on even smooth surfaces. If you run the tank without the top hull and turret it is perfect so l believe that the motors are not able to cope with the weight. Is this a common problem? I don’t know what to do about this. Any ideas.